EaseLife 6FT/72in Bypass Double Sliding Pocket Door Hardware Kit, Commercial Grade, Aluminum, Bypassing Closet Doors Track for 2 Door System, Slide Smoothly Quietly, Easy Install,No Door

Nice and smooth with 2 bypass oak doors! Heavy duty!

Great design and easy to install. I used a hacksaw to cut the track to length and used the screws that came with it to screw it to the ceiling of the door jam. The wheels are high-quality and slide silently. Very easy to attach to the track as well. It does give you the ability to raise and lower slightly at the top with the included tool.** hint - make sure the track is level or the doors will slide to the lower point. I had to use a shim to get it level.

Recently purchured this item for hanging darn doors on cabinet in my garage. The product worked great!

I don’t normally leave product reviews but I felt this was worthy. First off, this product is well built and sturdy. It rolls well and made a great improvement to our closets. However, what they don’t tell you is that this system is better if your closet doors are on a hard wood floor. If the doors are on carpet, beware. This system is 3/8 of an inch larger than a standard bypass door track. Because we have carpeted floors, I had to use a planer and shave almost a 1/4” off of every door to get this system to work. I am happy with the outcome but it took some work and having the right tools to make it work.

Easy to install and it slides freely.

Good quality and includes all needed pieces. Dimensions are as described.

We have a 15-year-old home with sliding bypass doors. Overtime the original hardware has worn out and needed replaced. However, We have not been able to find hardware that causes them to slide properly. Apparently it has been discontinued. Thankfully, we found this on Amazon and it worked perfectly. Installation was a bit Challenging. Installing the overhead piece was very simple, But our doors were too long because the overhead piece caused them to hang lower. We had to trim the bottoms of the doors but they have nails near the bottom which caused our saw to overheat. We also found it a little difficult to get the Hardware on the top into the sliders. Lastly, our doors are a little narrower than the floor guide. The sliders At the top move so smooth That the doors would not stay closed. Eventually, we were able to get to the doors in place and make them work properly and we are very very happy with the final result.

96 inches you guys have two 48" tracksNo what i wanted