Description
- DJ I Air Unit Connection Way:Two ways Supported ,6-pin connection or direct soldering 6-pin DJ I Air Unit Plug:Supported,Completely compatible with DJ I O3/Runcam Link/Caddx Vista/DJ I Air Unit V1,no wire is needed to be changed Blackbox MicroSD Card Slot :Betaflight firmware requires the type of the microSD card to be either Standard (SDSC) or High capacity (SDHC) under 32GB,so extended capacity cards(SDXC) are not supported (Many high-speed U3 cards are SDXC)
- Also the microSD card MUST be formatted with the FAT16 or FAT32 (recommended) format. So,you could use any SD card less than 32GB,but the Betaflight can only recognize 4GB maximum.We suggest you use this 3rd party formatting tool and choose 'Overwrite format' then format your card. Also check out here for the recommended SD cards or buy the tested cards from our store
- 5V BEC Output :9 groups of 5V output, (4 +5V pads on the front and 1 BZ+ buzzer pad, and one +5V pad on each of the 4 corners for external LED lights), the total current output is 3A 9V BEC Output :2 groups of 9V output, (1 +9V pad on the front, +9V output in a seat on the back), the total current output is 3A 3.3V BEC Output :Supported.Designed for 3.3V iutput receivers.Up to 500mA current load
- [A].Press and hold BOOT button and power the FC on at the same time will force the FC to enter DFU mode,this is for firmware flashing when the FC gets bricked. [B].When the FC is powered on and in standby mode,the BOOT button can be used to controller the LED strips connected to LED1-LED4 corrtors on the bottom side. By defaut,short-press the BOOT button to cycle the LED displaying mode.Long-press the BOOT button to switch between SpeedyBee-LED mode and BF-LED mode.
- Galvanometer Input: Supported. For SpeedyBee BLS 55A ESC , please set Scale=400 and Offset=0 Power input:3S - 6S Lipo (Through G, BAT pins/pads form the 8-pin connector or 8-pads on the bottom side) ESC signal: M1-M4 on the back and M5-M8 on the front UART serial port: 6sets (UART1, UART2, UART3, UART4 , UART5 , UART6) ESC telemetry input: R5 (UART5) I2C:Support. SDA & SCL pads on the front. For magnetometers, sonar, etc.
SPARKHOBBY SpeedyBee F405 V4 BLS 55A Stack ICM42688P F405 V4 FC BLHELIS 55A 4in1 ESC 3~6S Lipo 30x30mm for RC FPV Racing Drones DIY Parts (SB-F4V4-55-STACK)
